tag:blogger.com,1999:blog-3849017459291954430.post3052112194149125936..comments2024-03-26T19:56:36.025-07:00Comments on Shop Teacher Bob: Makin' MountsUnknownnoreply@blogger.comBlogger3125tag:blogger.com,1999:blog-3849017459291954430.post-16442999138352931212016-09-22T07:31:53.432-07:002016-09-22T07:31:53.432-07:00No problem. I'll be glad to help.No problem. I'll be glad to help.Surlyhttps://www.blogger.com/profile/11809693173008695179noreply@blogger.comtag:blogger.com,1999:blog-3849017459291954430.post-82667516283164805742016-09-22T05:34:18.503-07:002016-09-22T05:34:18.503-07:00I sent an e-mail off to the company I bought the l...I sent an e-mail off to the company I bought the lights from to see which wire goes where. I'm relatively certain the black wire is a ground, which means of the remaining wires, one is for the tail lights, the other for either the brake or turn signal. However, I don't anything about the necessity of using resistors with these. When I get ready to hook everything up, I'll be looking for some help.Shop Teacher Bobhttps://www.blogger.com/profile/00149540228110391917noreply@blogger.comtag:blogger.com,1999:blog-3849017459291954430.post-70153250643387549992016-09-21T10:29:05.794-07:002016-09-21T10:29:05.794-07:00If you reverse polarity on a diode they're don...If you reverse polarity on a diode they're done. Double check the wiring. Also, LED's work better with the correct size resistor inline. Some automotive LED bulbs don't have them but just know they might do odd things like blink or at worst, burn out. I have a selection of resistors for 12V LED's and there are calculators online to tell you which resistors to use with a given bank of diodes. Forgive me if you know this but I'd hate for you to let the smoke out of your fancy new tail lights. Surlyhttps://www.blogger.com/profile/11809693173008695179noreply@blogger.com