Wednesday, July 23, 2014

Got My Mojo Workin' Today


Here we have the complete arsenal for removing a key from the bottom of the crankcase - Maglite, inspection light with magnet on the end, epoxy, double sided tape, pick-up tool, hemostat, TIG filler rod, and a piece of sheet metal. I cut the piece of sheet metal and put a little hook on the end and it was doing fine dragging the key up the side of the case as I was turning the crank until it got almost to the top and then the clearance tightened up. I poked it down to the bottom again and finally managed to get it turned so it was aligned with the slot between the flywheels. Then it was just a matter of getting the hole in the top of the key over the drain plug hole and slipping the hook in the end of the wire up into the hole and hoisting away. Sure glad that's over. Since I rarely have the time to do things once, I hate to have to do things twice, especially something like jerking the motor all apart again. Even more so when it's my own stupidity.


However, picking up where I left off, I've got the cams in and the cover on so I can check the end play. I'll get that done yet today so I can pick up the shims tomorrow. I like the look of the stainless Allen bolts in the cover. I need to buy a long reach wrench for them that fits a 3/8" drive ratchet. I've got a couple of the long reach Allens in the most commonly used metric sizes and they are handy as hell.  



And might as well finish up with a little Muddy Waters - the man who always had his Mojo workin'.





1 comment:

tvi said...

HEY BOB, HARBOR FREIGHT SELLS SOME VERY NICE LONG ANGLE HEW WRENCH SETS WITH A BALL SOCKET ON THE END OF THEM. THEY GO ON SALE FOR 9.99 QUITE OFTEN. CHECK IT OUT.

TALK TO YOU SOON,

TVI